kbin.earth - content aggregator and micro-blogging platform for the fediverse

The one universal gender

https://lemmy.blahaj.zone/pictrs/image/750d7a6a-eed6-422b-91db-2bc6db3d88c7.jpeg

Just how secure are the various reverse proxy options?

Specifically from the standpoint of protecting against common and not-so-common exploits....

Shoot em ups & run n' guns

What are your favourite shoot em or run and gun games?...

What should I know about buying / replacing a garage door opener?

My default buying process is research + spreadsheet creation, this time thought I'd ask the community here if you have any experience / wisdom with garage door openers. Thanks for any help!...

Need a good resource to learn linux

I just fucking can't with windows anymore. I'd preach about it but I imagine you've heard it all. I have minimal computer expertise....

Crappy local infrastructure thread

Thread to vent about the dangerous and inefficient infrastructure you have to deal with.

No internet in virtual machine

I have on the host machine two network interfaces. One is lan and the other is a wlan. For libvirt I have created a nat network which is bound to the wlan. From the guest I can access other machines in the network host wlan is connected to. Also DNS lookup works. The problem is that there's no connection to the internet at all,...

California Polluters Pay Climate Cost Recovery Act made it to the state Senate floor - call your state senator and ask them to pass it

SB 1497 cleared committee, which means that the whole state Senate will vote on it....

Auto bed leveling on Ender 3 Max Neo

When printing on my Ender 3 Max Neo (stock except for a PEI bed), the right side of the bed is always printing too close. I manually leveled the bed, and then I run the auto-leveling sequence. I also have it set to run auto-level before every print, and confirmed that it's enabled using M420 S1 after the G29 in the opening...